#Aku shaper specifications full#

Table 19: Austhane AUE276 specifications (Australian Urethane Systems, 2010). The angular bands maintain their angle, but narrow until they come together at the nose to form the beak. Figure 11: AKU shaper machine (AKU Shaper, 2016). To do that is easy if you use a more angular, down rail. It's a pretty short distance from the wide point to the nose, so if it ends up slightly thicker in the nose than the tail, that's ok. You might even go a touch thicker than that in the nose area if you can't get a good, smooth foil from the pushed-forward thick point. If you go with 2 3/4 at the thick point, which is a few inches ahead of center, I'd go about 1 3/4 thick both at a foot back from the nose and a foot up from the tail.

#Aku shaper specifications full#

Our main products is stand-up paddle board, race board, surfboard, skimboard, body board, paddle, and various accessories of water sports products.For 6 years development, our company have developed a full range of water sports products. During the production process it must be ensured that these specifications are observed and that no product mix-ups occur. Yuan Sport is established in 2006, which is specializes in supplying water sports products. This information is located on the top and bottom of the packaging. it can also be mounted in a router table, creating a small stationary shaper. These are designed in a variety of ways, have to comply with legal requirements for the best before date and tables of contents and must be clearly labelled. Renault R8 Gordini look and specifications 1965. Normally the tail is a bit thicker than the nose, but on retro fish, they're closer to the same so that the volume the board loses due to it's short length can be made up in thickness. piece of steel with a dust channel milled to exacting specifications. Our mobile mechanics will service your Renault at your home or office. Keeping your rocker curve a nice, single, continuous curve, like you're doing, is a good thing.Īs far as thickness goes, I like my thickest point to be at the widepoint, with my nose and tail thicknesses a foot from the ends to be about the same. You could go slightly flatter in the tail if you give it heavier vee. I don't know how the thickness should be treated through the entire board.

The other problem is: I have basically been using the center width, nose rocker, and tail rocker in AKU shaper and just using the tangents to smooth out the line. I'm interested in wave catching ability and stability. I'm totally new to this but I know I don't want too much rocker.

So far I have played around with rocker recommendations of as much as 2 1/2' tail and 5' nose and as little as 3 1/2'Nose and 1 1/2' tail. These dimensions are based on various boards I like and some tweaking on AKU shaper. I'm still playing around with the outline but so far it will be 6'0' x 22 (3' forward of center) with a 16' nose and tail, 2 3/4' thick. It will be a fish and I'm going to build it out of a block of EPS using templates with a hot wire cutter.